Pan/Tilt/Zoom (PTZ) Settings

Click bitmap button Config and select PTZ to enter the PTZ panel:

  Step 1: Set "Enable camera control" to the checked state.

  Step 2: Set the Protocol (if your PTZ camera was purchased from eDigitalDeals, this should be set to Pelco D)

  Step 3: Select a baudrate (if your PTZ cameras was purchased from eDigitalDeals, this should be set to 2400)

  Step 4: Com should always be set to Com 1.

  Note: Preset functions in the left column are not active. This functionality is not incorporated into the software.